Abstract：The effects of different setpoints on image quality, measuring accuracy, wear pattern of probe and sample in different testing mode were investigated. The results indicated that in contact mode, the larger the setting of the bending amount, the greater the interaction force between the probe and the sample, the noise was decreased, the image quality was increased, however it caused great wear to the sample and the probe, and reduce the measurement accuracy. Generally, the hard sample with large surface fluctuation is suitable for this mode. In tapping mode, the needle set an amplitude, from the value starts, as the amplitude decreased, the measurement accuracy and probe wear degree increased firstly and then decreased, and the noise and wear were not large, so the mode suit for non sticky samples with smooth surface. In the intelligent mode, the parameters were adjusted automatically, and the wear of the sample and probe was small, but the influence by the noise was great and the accuracy was low when the measurement data was small.
唐莹, 曹丛, 张健, 赵东升. AFM设定值对测量准确度和探针寿命的影响[J]. 计量学报, 2019, 40(6A): 17-22.
TANG Ying, CAO Cong, ZHANG Jian, ZHAO Dong-sheng. The Effects of Different Setpoint to Measuring Accuracy and Service Life of a Probe on AFM. Acta Metrologica Sinica, 2019, 40(6A): 17-22.
1 朱杰, 孙润广. 原子力显微镜的基本原理及其方法学研究［J］. 生命科学仪器, 2005, 3(1): 22-26. ZhuJ, SunR G. Introduction to Atomic Force Microscope and its Manipulation［J］. Life Science Instruments, 2005, 3(1): 22-26.
2 姚雅萱, 任玲玲, 高思田, 等. 石墨烯层数测量方法的研究进展［J］. 化学通报, 2015, 78(2): 100-106. YaoY X, RenL L, GaoS T, et al. Progress in measuremental methods for layer numbers of graphene［J］. Chemistry, 2015, 78(2): 100-106.
3 李洁爱, 徐凌云. 参数设定对原子力显微镜测试的影响 ［J］. 分析仪器, 2013, （2）: 35-40. LiJ A, XuL Y. The effects of different parameters on atomic force microscope［J］. Analytical Instrumentation, 2013, （2）: 35-40.
4 柯丁宁, 况婷, 宋琳琳, 等. 基于超平表面的原子力显微镜探针磨损研究［J］. 分析测试学报, 2019, 38(7): 870-873. KeD N, KuangT, SongL L, et al. Study on Tip Wear of Atomic Force Microscope Using Ultra-flat Surface［J］. Journal of Instrumental Analysis, 2019, 38(7): 870-873.
5 王雪, 张茜, 吴晓辉, 等. 原子力显微镜在弹性体材料微观结构表征中的应用［J］. 高分子材料科学与工程, 2019,35（7）:160-166. WangX, ZhangQ, WuX H, et al. Application of Atomic Force Microscope in Characterization of Microstructure of Elastomer Materials［J］. Polymer Materials Science & Engineering, 2019,35（7）:160-166.
6 AlbrechtT R, GrutterP, HorneD, et al. Frequency modulation detection using high-Q cantilevers for enhanced force microscope sensitivity ［J］. Journal of Applied Physics, 1991, 69(2): 668-673.
7 ZhongQ, InnissD, KjollerK, et al. Fractured polymer/silica fiber surface studied by tapping mode atomic force microscopy［J］. Surface Science Letters, 1993, 290(1-2): L688-L692.
8 OverneyR M, MeyerE, FrommerJ, et al. Force microscopy study of friction and elastic compliance of phase-separated organic thin films［J］. Langmuir, 1994, 10(4): 1281-1286.
9 赵春花. 原子力显微镜的基本原理及应用［J］. 化学教育, 2019, 40(4): 10-15. ZhaoC H. Principles and Application of Atomic Force Microsocopy［J］. Chinese Journal of Chemical Education, 2019, 40(4): 10-15.
10 陈注里, 李英姿, 钱建强, 等. 原子力显微镜的几种成像模式简介［J］. 电子显微学报, 2013,32(2): 178-186. ChenZ L, LiY Z, QianJ Q, et al. Overview of the atomic force microscope about imaging methods［J］. Journal of Chinese Electron Microscopy Society, 2013, 32(2): 178-186.
11 BinnigG, QuateC F, GerberC. Atomic force microscope［J］. Phys Rev Lett, 2018, 56: 930-933
12 徐井华, 李强. 原子力显微镜的工作原理及其应用［J］. 通化师范学院学报, 2013, 34(2): 22-24. XuJ H, LiQ. Working mechanism and application of atomic force microscope［J］. Journal of Tonghua Normal University, 2013, 34(2): 22-24.
2019, Vol. 40 
