Abstract：According to temperature value of the high temperature end of heat meter and the characteristics of temperature cycle control in the verification process, an intelligent replacement thermostatic tank and application system for temperature measurement were developed.By setting up a group of water tanks and electronic control components, rapid switching of water temperature points was ensured in high temperature water constant temperature tank to meet the requirements of rapid verification of heat meters.The practical principle and method of the intelligent replacement type constant temperature tank and the practical operation guidance of control system were given.The system used the self-made numerical control technology, takes the reference slot as the main measuring body, assisted the tank to prefabricate the constant temperature medium, and build the replacement platform for the intermediate slot.The experimental results showed that the equipment meet the requirements of JJF 225—2001 《Heat Meter》, GB/32224—2015 《Heat Meter》, JJF 1030—2010 《Measurement and Test Norm of Thermostatic Bath′ Metrological Characteristic》and JJF (Mongolia) 033—2018 《Replacement Type Thermostatic Bath Calibration Specification》.The rapid measurement of the temperature can be realized in the heat meter verification process by this method, and the verification efficiency was also improved about one time.
杨焕诚. 智能置换式恒温槽测量系统的应用研究[J]. 计量学报, 2019, 40(6): 1037-1042.
YANG Huan-cheng. Research on the Application of the Intelligent Replacement Type Thermostatic Bath Measurement System. Acta Metrologica Sinica, 2019, 40(6): 1037-1042.
［1］Goldenberg N, Wool A. Accurate modeling of Modbus/TCP for intrusion detection in SCADA systems［J］. International Journal of Critical Infastructure Protection, 2013, 2(6):2-3.
［2］Carlose E. Communication bridge links Modbus RTU and TCP vis web［J］. Electronics Weekly,2013,25(1):20-25.
［3］Park K. A differential equation for vapor pressure as a function of temperature ［J］. Fluid Phase Equilibria, 2010, 29(3):155-156.
［4］JJF(蒙)033—2018 置换式恒温槽校准规范［S］. 2018.
［5］国家质量监督检验检疫总局. JJF 1030—2010 恒温槽技术性能测试规范［S］. 2011.
［6］中华人民共和国建设部. CJ 128—2007 热量表［S］. 2008.
［7］阎军. 用固体热泵构成的热电偶冷端0℃恒温槽［J］. 国外计量, 1987,(6): 68-69.
［8］杨秋兰. 专家PID控制在微型精密恒温槽中的应用研究［J］. 价值工程, 2010,30(17): 89-90.
Yang Q L.Expert PID Control in Minature Precise Thermostart Applied Research［J］. Value Engineering, 2010, 30(17): 89-90.
［9］宋德华. 热管恒温槽的性能分析［J］. 计量学报, 2007, 28(z1): 121-124.
Song D H. Function Anahysis of the Heat-pipe Thenmostat［J］. Acta Metrologica Sinica, 2007, 28(z1): 121-124.
［10］孙立堂. 高精度数字测温仪在恒温槽温场测试中的应用［J］. 中国计量, 2014,(8): 104-105.
2019, Vol. 40 
