一种新型的交流阻抗计量标准装置

doi:10.3969/j.issn.1000-1158.2020.05.16

摘要
图/表
参考文献(14)
相关文章 (15)

全文: PDF (495 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要为解决任意阻抗模与阻抗角的交流阻抗的溯源问题,研制了一套新型交流阻抗标准装置,由交流阻抗标准源及交流阻抗标准表组成,在100Hz~1MHz、0.1Ω~1kΩ范围,可对RLC数字电桥、交流阻抗和实物阻抗进行校准,技术指标可以达到0.01%。采用直接测量法、替代测量法和等电位测量法,将交流阻抗标准溯源到实物阻抗标准、电压比例标准和相位标准上,形成了一条完整的交流阻抗溯源链。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	颜晓军
	扈蓓蓓
	李亚琭
	吴康
	游立

关键词 ：计量学, 交流阻抗标准装置, 直接测量法, 替代测量法, 等电位测量法

Abstract：A new type of AC impedance measurement standard is developed, which can resolve the traceability problem of AC impedance by producing any amplitude and angle. Between 100Hz to 1MHz, 0.1Ω to 10kΩ, the new type of AC impedance measurement standard, which is composed of AC impedance standard source and meter, can calibrate RLC digital meter, AC impedance and material impedance, and the best accuracy is 0.01%. By using direct measurement, substitution measurement and equipotential measurement, AC impedance measurement standard can be traced to material impedance standard, voltage ratio standard and phase standard. Thus a traceability chain of AC impedance is formed.

Key words： metrology AC impedance measurement standard direct measurement substitution measurement equipotential measurement

收稿日期: 2019-09-19

PACS:

TB971

作者简介: 颜晓军(1988-),女,山东威海人,北京东方计量测试研究所工程师,主要从事仪器仪表精密测量方面的工作。Email: yanxiaojun001@163.com

引用本文:

颜晓军,扈蓓蓓,李亚琭,吴康,游立. 一种新型的交流阻抗计量标准装置[J]. 计量学报, 2020, 41(5): 602-607.
YAN Xiao-jun,HU Bei-bei,LI Ya-lu,WU Kang,YOU Li. A New Type of AC Impedance Measurement Standard Device. Acta Metrologica Sinica, 2020, 41(5): 602-607.

链接本文:

http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2020.05.16 或 http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2020/V41/I5/602

［1］Overney F, Jeanneret B. Impedance simulator for automatic calibration of LCR meters over the entire complex plan［C］//IEEE. Washington, DC, 2012: 684-685.
［2］Oldham N M, Booker S R. Programmable Impedance Transfer Standard to Support LCR Meter［C］//IEEE. Instrumentation & Measurement Technology Conference. 1994:929-930.
［3］国家质量监督检验总局. GJB/J 5412—2005宽量程数字RLC测量仪检定规程［S］. 2005.
［4］曾涛, 鲁云峰, 张钟华, 等. 线面式电容传感器结构设计与传感特性研究［J］. 计量学报, 2019, 40(6): 941-945.
Zeng T, Lu Y F, Zhang Z H, et al. Research in the structure design and sensing characteristics of the filament-surface capacitive sensor［J］. Acta Metrologica Sinica, 2019, 40(6): 941-945.
［5］刘民. 数字模拟阻抗标准器: ZL200510082928.X［P］. 2005-12-21.
［6］李亚琭, 刘民, 魏强. 数字模拟阻抗标准器的实现［J］. 宇航计测技术, 2009, 29(3): 49-53.
Li Y L, Liu M, Wei Q. The Realization of Digital Simulation Impedance Standard［J］. Journal of Astronautic Metrology and Measurement, 2009, 29(3): 49-53.
［7］Yan X J, Li Y L, You L. Design and Analysis of Complex Impedance Standard ［C］// IEEE. 2013 IEEE 11th International Conference on Electronic Measurement & Instruments (ICEMI). 2013.
［8］潘洋, 周力任, 冯建. 一种新型低值宽带无感分流器时间常数测量方法［J］. 计量学报, 2019, 40(6): 946-951.
Pan Y, Zhou L R, Feng J. A New Method for the Measurement of Time Constant of Low Value Wide Band Non-inductance Current Shunt［J］. Acta Metrologica Sinica, 2019, 40(6): 946-951.
［9］Li Y U, Liu M. The effect on total harmonic distortion by DAC in digital wave synthesis technique［C］// Measurement and Test Committee of Chinese Society of Astronautics Academic Symposium, 2006.
［10］Liu M, Li Y, Wei Q. Research on Simulation Impedance［C］// 2008 Conference on Precision Electromagnetic Measurements Diges. Broomfield, CO, USA, 2008: 574-575.
［11］Wu K, Li Y L, Liu M The Implementation of the New Type Impedance Measurement System［C］//IEEE. General Assembly & Scientific Symposium. 2014.
［12］Dutta M, Rakshit A, Bhattacharyya S N. Development and Study of an Automatic AC Bridge for Impedance Measurement［J］. IEEE Trans Instrum Meas , 2001, 50(5): 1048-1052.
［13］Nilangshu K D, Jayakumar T, Baldev Raj. Noniterative Digital AC Bridge Balance［J］. IEEE Trans Instrum Meas, 2010 , 47(2): 1-3.
［14］颜晓军, 李亚琭, 吴康, 等. 一种有源模拟阻抗标准器的实现方法［J］. 宇航计测技术, 2016, 36(5): 24-27.
Yan X J, Li Y L, Wu K, You L, et al. Design and Realization of Complex ImpedanceSimulation ［J］. Journal of Astronautic Metrology and Measurement, 2016, 36(5), 24-27.