基于脉冲涡流热成像的面内方向性热扩散率测量

doi:10.3969/j.issn.1000-1158.2019.00.15

摘要
图/表
参考文献(20)
相关文章 (15)

全文: PDF (1606 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要针对导电材料面内方向性热扩散率的测量,提出脉冲涡流热成像法这一新方法。该方法采用感应式脉冲线激励源,在导电试件表面形成沿一定方向的感应涡流,实现局部热激励,在非稳态条件下实现了材料面内方向热扩散率的测量;简单调节试件与线感应激励线圈的角度,就可以快速无损非接触地测量试件在垂直线圈方向上的热扩散率值。对感应线激励下面内热传导及高斯温度分布进行了分析,分别对AISI304不锈钢、纯铁、纯镍3种材料的热扩散率进行了测量,测量结果与手册值相符,偏差小于9.0%,相对扩展不确定度分别为3.18%,3.72%,3.70%。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	余开科
	田裕鹏
	王平
	尹相杰
	贾兴伟
	董世运

关键词 ：计量学, 热扩散率, 红外热成像, 脉冲感应涡流, 方向性

Abstract：To measure the in-plane directional thermal diffusivity of the conductive material, a new method called pulsed eddy current thermography is proposed. Eddy current along a certain direction is induced on the surface of the conductive material by using an inductive pulsed line excitation to achieve local heating. Under non-steady conditions, simply changing the relative position between the sample and the coil can quickly and non-destructively measure the diffusivity in the vertical direction of the coil. The in-plane heat conduction and the Gaussian temperature distribution are analyzed on the condition of the inductive pulsed line excitation. The AISI304 stainless steel, pure iron, and pure nickel are measured and the measurement results are in accordance with the literature values, all the deviations are less than 9.0% and the relative extended uncertainty is 3.18%,3.72% and 3.70% respectively.

Key words： metrology thermal diffusivity thermography pulsed eddy current directionality

收稿日期: 2018-05-31 发布日期: 2019-10-10

PACS:

TB941

基金资助:国家科技部重大开发专项(2016YFB1100205);国家科技部重点研发专项(2017YFF0209700);国家重大科研仪器研制项目(61527803);科技部重大科学仪器设备开发专项(2016YFF0103702);航空基金(2015ZF52067)

通讯作者: 田裕鹏(1964-),男,山东潍坊人,南京航空航天大学教授,主要研究方向为红外热成像及无损检测。Email: yptian@nuaa.edu.cn E-mail: yptian@nuaa.edu.cn

作者简介: 余开科(1992-),男,江苏淮安人,南京航空航天大学硕士,主要研究方向为红外热成像及无损检测。Email: kaikeyu@qq.com

引用本文:

余开科,田裕鹏,王平,尹相杰,贾兴伟,董世运. 基于脉冲涡流热成像的面内方向性热扩散率测量[J]. 计量学报, 2019, 40(6): 1030-1036.
YU Kai-ke,TIAN Yu-peng,WANG Ping,YIN Xiang-jie,JIA Xing-wei,DONG Shi-yun. Measurement of In-plane Directional Thermal Diffusivity Using Pulsed Eddy Current Thermography. Acta Metrologica Sinica, 2019, 40(6): 1030-1036.

链接本文:

http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2019.00.15 或 http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2019/V40/I6/1030

［1］Parker W J, Jenkins R J, Butler C P, et al. Flash Method of Determining Thermal Diffusivity, Heat Capacity, and Thermal Conductivity［J］. Journal of Applied Physics, 1961, 32(9): 1679-1684.
［2］孙建平, 刘建庆. 样品厚度对热扩散率测量影响的实验研究［J］. 计量学报, 2007, 28(z1): 86-89.
Sun J P, Liu J Q. Investigation on the Influence of Sample Thickness on the Measurement Result of Thermal Diffusivity［J］. Acta Metrologica Sinica, 2007, 28(z1): 86-89.
［3］Cernuschi F, Russo A, Lorenzoni L, et al. In-plane thermal diffusivity evaluation by infrared thermography［J］. Review of Scientific Instruments, 2001, 72(10): 3988-3995.
［4］Cernuschi F, Bison P G, Figari A, et al. Thermal Diffusivity Measurements by Photothermal and Thermographic Techniques［J］. International Journal of Thermophysics, 2004, 25(2): 439-457.
［5］Pech-May N W, Mendioroz A, Salazar A. Simultaneous measurement of the in-plane and in-depth thermal diffusivity of solids using pulsed infrared thermography with focused illumination［J］. Ndt & E International, 2016, 77: 28-34.
［6］王晓娜, 厉阳, 侯德鑫, 等. 基于热成像的薄片材料热扩散率快速无损检测［J］. 计量学报, 2016, 37(3): 260-264.
Wang X N, Li Y, Hou D X, et al. A Rapid and Nondestructive Detection on the Thermal Diffusivity of Thin Materials Based on Thermography［J］. Acta Metrologica Sinica, 2016, 37(3): 260-264.
［7］Ishizaki T, Nagano H. Measurement of Three-Dimensional Anisotropic Thermal Diffusivities for Carbon Fiber-Reinforced Plastics Using Lock-In Thermography［J］. International Journal of Thermophysics, 2015, 36(10): 2577-2589.
［8］厉阳, 侯德鑫, 叶树亮. 基于热成像的材料热扩散率测量方法研究［J］. 计量学报, 2017, 38(1): 28-33.
Li Y, Hou D X, Ye S L. Research on Measurement Method of Thermal Diffusivity of Materials Based on Thermography［J］. Acta Metrologica Sinica, 2017, 38(1): 28-33.
［9］贾志海, 牛刚, 王经, 等. 利用红外热成像技术测算碳纤维材料的热扩散系数［J］. 计量学报, 2004, 25(4): 336-338.
Jia Z H, Niu G, Wang J, et al. The Measurement of the Thermal Diffusivity of Some Carbon Fiber Materials Using Infrared Imaging Technology［J］. Acta Metrologica Sinica, 2004, 25(4): 336-338.
［10］Laskar J M, Bagavathiappan S, Sardar M, et al. Measurement of thermal diffusivity of solids using infrared thermography［J］. Materials Letters, 2008, 62(17–18): 2740-2742.
［11］Basheer C M, Krishnamurthy C V, Balasubramaniam K. Hot-Rod Thermography for In-plane Thermal Diffusivity Measurement［J］. Measurement, 2017, 103: 235-240.
［12］Shekhani H N, Uchino K. Thermal diffusivity measurements using insulating and isothermal boundary conditions［J］. Review of Scientific Instruments, 2014, 85(1): 015117.
［13］Bison P G, Grinzato E, Marinetti S. Local thermal diffusivity measurement［J］. Quantitative Infrared Thermography Journal, 2004, 1(2): 241-250.
［14］Brown G H, Hoyler C N, Bierwirth R A. Theory and application of radio-frequency heating ［M］. Princeton: D Van Nostrand Company Inc, 1947.
［15］戴维斯, 辛普森. 感应加热手册［M］. 北京: 国防工业出版社, 1985.
［16］Gu Y, Hatta I. Effect of Sample Edge in ac Calorimetric Method for Measuring Thermal Diffusivity of Thin Films with High Thermal Diffusivity［J］. Japanese Journal of Applied Physics, 1991, 30(5): 1137-1138.
［17］ASM. Metals Handbook: Desk Edition［M］. Ohio:ASM International,1998.
［18］谭真, 郭广文. 工程合金热物性［M］. 北京: 冶金工业出版社, 1994.
［19］MatWeb Material Property Data［EB/OL］.http://www.matweb.com/search/DataSheet.aspx?MatGUID=abc4415b0f8b490387e3c922237098da&ckck=1,2018-05-10.
［20］倪育才. 实用测量不确定度评定［M］. 北京: 中国计量出版社, 2009.