1.National Key Laboratory of Science and Technology on Metrology and Calibration, Changcheng Institute of Metrology and Measurement, Beijing 100095, China;
2.College of Precision Instrument and Opto-electronics Engineering, Tianjin University, Tianjin 300072, China
Abstract：Aiming at the partial period sinusoidal waveform sampling series, the definition of signal to noise ratio of sampling series (SNR) and the noise to signal ratio of sampling series (NSR) are put forward. By using the method of varying known parameters of partial period of sinusoidal waveforms and the Gauss noise level, when the width of period, phase, and SNR are varied, the varying rules of curve-fitting error of partial period sinusoidal are studied by experiments. The results show that, in partial period sinusoidal curve-fitting, the varying rule between NSR and phase of sinusoidal series is fixed, all the curve-fitting errors of amplitude, frequency, phase, and DC bias vary as NSR. The partial period sinusoidal curve-fitting errors can be estimated by using simulation with curve-fitting parameters. In experiment, the validity and feasibility of the method above are proved.
［1］ IEEE Std 1057-1994, IEEE Standard for Digitizing Waveform Recorders ［S］. 1994
［2］ Kuffel J,McComb T R, Malewski R. Comparative Evaluation of Computer Methods for Calculating the Best-Fit Sinusoid to the Digital Record of a High-Purity Sine Wave ［J］. IEEE Transactions on Instrumentation and Measurement, 1987, 36(3): 418-422.
［3］ McComb T R, Kuffel J, Roux B C L. A Comparative Evaluation of Some Practical Algorithms Used in the Effective Bits Test of Waveform Recorders［J］.IEEE Transactions on Instrumentation and Measurement, 1989, 38(1): 37-42.
［4］ Jeng Y C. High precision sinusoidal frequency estimator based on weighted least square method［J］. IEEE Transactions on Instrumentation and Measurement, 1987, 36(2): 124-127.
［5］ Jenq Y C, Crosby P. Sinewave parameter estimation algorithm with application to waveform digitizer effective bits measurement ［J］. IEEE Transactions on Instrumentation and Measurement, 1988, 37(4): 529-532.
［6］ Cennamo F, Daponte P, Savastano M. Dynamic testing and diagnostics of signal analyzers［J］. IEEE Transactions on Instrumentation and Measurement, 1992, 41(6): 840-844.
［7］ Giaquninto N, Trotta A. Fast and accurate ADC testing via an enhanced sine wave fitting algorithm ［J］. IEEE transactions on Instrumentation and Measurement, 1997, 46 (4): 1020-1025.
［8］ Dallet D, Slepicka D, Berthoumieu Y, et al. ［ADC Characterization in Time Domain］ Frequency Estimation to Linearize Time-Domain Analysis of A/D Converters ［J］. IEEE Transactions on Instrumentation and Measurement, 2006,55(5): 1536-1545.
［9］ Zhang J Q, Zhao X M, Hu X, et al. Sinewave fit algorithm based on total least-squares method with application to ADC effective bits measurement［J］. IEEE transactions on Instrumentation and Measurement, 1997, 46 (4): 1026-1030.
［10］ 梁志国,张大治,孙璟宇,等. 四参数正弦曲线拟合的快速算法［J］. 计测技术,2006,26(1): 4-7.
［11］ 田社平,王坚,颜德田,等. 基于遗传算法的正弦波信号参数提取方法［J］. 计量技术,2005,(5):3-5.
［12］ 梁志国,朱济杰,孟晓风. 四参数正弦曲线拟合的一种收敛算法［J］. 仪器仪表学报,2006,27(11):1513-1519.
［13］ 梁志国,孟晓风.残周期正弦波形的四参数拟合［J］.计量学报,2009,30(3): 245-249.
［14］ Liang Zhiguo, Lu Kejie, Sun Jingyu. Evaluation of Software of Four-Parameter Sine Wave Curve-fit ［J］. Transaction of Nanjing University of Aeronautics & Astronautics, 2000, 17(1): 100-106.
［15］ 梁志国,孟晓风.正弦波形参数拟合方法述评［J］.测试技术学报,2010,24(1):1-8.
［16］ Handel P. Properties of the IEEE-STD-1057 Four-Parameter Sine Wave Fit Algorithm［J］. IEEE Transactions on Instrumentation and Measurement, 2000, 49(6): 1189-1193.
［17］ Deyst J P, Souders T M, Solomon O M. Bounds on least-squares four-parameter sine-fit errors due to harmonic distortion and noise ［J］. IEEE Transactions on Instrumentation and Measurement, 1995, 44(3): 637-642.
［18］ Andersson T, Handel P. IEEE Standard 1057, Cramer-Rao Bound and the Parsimony Principle［J］. IEEE Transactions on Instrumentation and Measurement, 2006, 55(1): 44-53.
［19］ Moschitta A, Carbone P. Cramer-Rao Lower Bound for Parametric Estimation of Quantized Sinewaves ［J］. IEEE Transactions on Instrumentation and Measurement, 2007, 56(3): 975-982.
2013, Vol. 34 
