Abstract：The two evaluation methods for the turbine meter by the use of non-fixed point as master meter, linear interpolated method and curve fitting method were presented in detail. On the base of calibration results of 10 pieces of turbine meters, the uncertainties for each method were calculated. The results showed that, the prediction of the curve fitting agreed very well with the calibration result, and the uncertainty was obviously smaller than that of the linear interpolated method.
李春辉, 李鹏. 作为标准表非定点使用的涡轮流量计评定方法探析[J]. 计量学报, 2015, 36(6): 610-612.
LI Chun-hui,LI Peng. The investigation on the evaluation for the turbine meter by the use of non-fixed point as master meter. Acta Metrologica Sinica, 2015, 36(6): 610-612.
1］苏彦勋,杨有涛. 流量检测技术［M］. 北京:中国质检出版社,2012,172-199.
［2］Tuskamoto H,Hutton S P. Theoretical prediction of meter factor for a helical turbine flowmeter［C］//Conference on Fluid Control and Measurement, Tokyo, Japan, 1985.
［3］秦红新,陈康民,赵学端.涡轮流量计转子内完全三元流场的变域变分有限元解(1)［J］.宇航计测技术,1990,（6）:51-54.
［4］Xu Y. A model for the prediction of turbine flowmeter performance［J］. Flow Measurement and Instrumentation,1992,3(1): 37-43.
［5］Baker R C. Turbine flowmeters: II. Theoretical and experimental published information［J］. Flow measurements and instrumentation,1993, 4(3): 123-144.
［6］国家质量监督检验检疫总局.JJG 1037 涡轮流量计检定规程［S］.2008.
［7］Bremser W, Hasselbarth W, Hirlehei U, et al.Uncertainty analysis and long-term stability investigation of the German primary high pressure natural gas test facility Pigsar［C］//11th International Conference on Flow Measurement, FLOMEKO' 2003, Groningen, The Netherlands, May 2003.
［8］肖明耀. 矩阵最小二乘法原理及应用［R］. 北京:中国计量科学研究院,1978.
2015, Vol. 36 
