旋入式检验级测压器鉴选方法研究

doi:10.3969/j.issn.1000-1158.2014.04.08

摘要
图/表
参考文献(9)
相关文章 (15)

全文: PDF (302 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要为消除压力源的波动,提出了一种运用相对偏差进行误差处理的鉴选方法。以1cm²旋入式测压器及常用的Φ6mm×9.8mm锥形铜柱作为研究对象,对旋入式检验级测压器进行了鉴选试验,并结合试验数据分析处理,对该方法的可行性进行了验证。结果显示该鉴选方法更科学合理。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	王芳
	李静
	孔德仁
	高路鹏

关键词 ：计量学, 旋入式检验级测压器, 鉴选方法, 鉴选判据

Abstract：The selection method using relative deviation to execute error processing is proposed to eliminate the fluctuation of stressors. With the crusher gauge of circumflex type with 1cm² and the conical copper cylinders withΦ6mm×9.8mm as the research objects, the test selecting are made for the testing-level crusher gauge of circumflex type. And with the analysis and treatment of the experimental data, the proposed assessment and the feasibility of the method has been validated. The results showe that the election method is more scientific and rational.

Key words： Metrology Testing-level crusher gauge of circumflex type Selection method Selection criterion

作者简介: 王芳（1966-）,女,山西大同人,南京理工大学博士研究生,主要从事武器动态参数测试。wangfang@mail.njust.edu.cn

引用本文:

王芳, 李静, 孔德仁, 高路鹏. 旋入式检验级测压器鉴选方法研究[J]. 计量学报, 2014, 35(4): 339-343.
WANG Fang, LI Jing, KONG De-ren, GAO Lu-peng. Study on Selection Method for the Testing-level Crusher Gauge of Circumflex Type. Acta Metrologica Sinica, 2014, 35(4): 339-343.

链接本文:

http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2014.04.08 或 http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2014/V35/I4/339