零差干涉仪用于振动校准中关键技术的研究

doi:10.3969/j.issn.1000-1158.2018.03.16

摘要
图/表
参考文献(12)
相关文章 (15)

全文: PDF (777 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要针对零差干涉仪用于低频振动校准中数据量过大的问题,分析了其输出干涉信号的特点,采用了一种动态相位的展开算法,该算法利用了振动过程中加速度量的信息,能够大大降低频振动校准时对采样率的需求,从而有效地减小了采集时的数据量。针对正弦振动参数计算的问题,采用了基于最小二乘算法的参数递推算法,既能避免参数计算是矩阵求逆等运算操作,还能实现参数的实时计算。结果表明,利用本文所述方法能够有效地拓宽零差干涉仪用于低频振动测量时的频率下限。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	胡红波
	杨丽峰
	于梅

关键词 ：计量学, 振动校准, 零差干涉仪, 相位展开, 正弦拟合

Abstract：For the problem of huge data encountered when homodyne interferometer is used in low frequency vibration calibration, first the properties of the spectrum of the interference is described, and then a dynamic successive phase unwrap algorithm is used, this method requires information about acceleration in the process. Based on this method, the sampling rate can be heavily reduced with losing information and a small capacity of data. During the process of the amplitude and phase angle estimation, a recursive method of least squares is recommended, with this method not only the computation of matrix inverse can be avoided, but also value of the parameters can be calculated online. To sum up, the methods proposed can broaden the low frequency range for vibration calibration using homodyne interferometer.

Key words： metrology homodyne interferometer vibration calibration phase unwrapping sine-approximation

收稿日期: 2017-11-09 发布日期: 2018-04-12

PACS:

TB936

通讯作者: 胡红波 E-mail: huhb@nim.ac.cn

作者简介: 胡红波(1980-), 湖北监利人, 中国计量科学研究院副研究员, 主要从事振动冲击基标准及测试技术的研究。huhb@nim.ac.cn

引用本文:

胡红波,杨丽峰,于梅. 零差干涉仪用于振动校准中关键技术的研究[J]. 计量学报, 2018, 39(3): 368-372.
HU Hong-bo,YANG Li-feng,YU Mei. Study on Key Technologies of Vibration Calibration Using Homodyne Interferometer. Acta Metrologica Sinica, 2018, 39(3): 368-372.

链接本文:

http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2018.03.16 或 http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2018/V39/I3/368

［1］ISO 1999 International Standard 16063-11 Methods for the calibration of vibration and shock transducers—Part 11: Primary vibration calibration by laser interferometry ［S］.1999.
［2］ISO 2001 International Standard 16063-13 Methods for the calibration of vibration and shock transducers—Part 13: Primary shock calibration using laser interferometry ［S］.2001.
［3］胡红波,孙桥,白杰. 基于窄脉冲冲击激励的压电加速度计动态校准［J］. 计量学报,2017, 38(2):184-188.
［4］于梅. 0.1 Hz～50 kHz直线振动幅值和相位国家计量基准系统的研究［J］. 振动与冲击,2007,26(7):54-58.
［5］于梅, 胡红波, 左爱斌,等. 新一代冲击加速度国家计量基准装置的研究与建立［J］.振动与冲击,2013,32(10):124-129.
［6］于梅, 孙桥, 冯源,等. 正弦逼近法振动传感器幅相特性测量技术的研究［J］. 计量学报,2004,25(4):344-348.
［7］SUN Q, Wabniski W, Thomas B. Investigation of primary vibration calibration at high frequencies using the homodyne quadrature sine-approximation method: problems and solutions［J］. Measurement Science & Technology, 2006, 17(8):2197-2205.
［8］Dániel I. Advanced successive phase unwrapping algorithm for quadrature output Michelson interferometers［J］. Measurement,2005, 37(2):95-102.
［9］Martens H V. Metrology of vibration measurements by laser techniques［C］// Eighth International Conference on Vibration Measurements by Laser Techniques: Advances and Applications. International Society for Optics and Photonics, 2008:709802-709802-24.
［10］胡红波,于梅. 零差激光干涉仪正交相位误差的分析［J］. 光电工程,2012,39(12):55-62.
［11］陈才生. 数学物理方程［M］. 北京:科学出版社,2008.
［12］方崇智,萧德云. 过程辨识［M］. 北京:清华大学出版社,1988.