基于时频增强的滚动轴承少样本故障诊断方法

doi:10.3969/j.issn.1000-1158.2023.01.03

摘要
图/表
参考文献(16)
相关文章 (15)

全文: PDF (5641 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要针对滚动轴承故障样本稀缺、振动特征提取困难导致故障诊断准确率低的难题,提出一种基于时频增强的滚动轴承少样本故障诊断方法。首先,对滚动轴承一维振动信号进行重叠采样,利用连续小波变换对采样信号段进行时频域特征映射,构造二维时频矩阵;其次,通过深度卷积生成对抗网络对真实时频样本进行训练后,将生成时频样本加入到训练集中;然后,采用时序卷积网络融合深层次的时频域特征;最后,构建Softmax分类器输出与故障类别对应的状态。仿真实验结果表明,在仅有10个训练样本的条件下,该方法在凯斯西储大学滚动轴承数据集中的诊断准确率均值达91.00%,相较未经时频增强的方法提高了7.56%,并利用实测数据验证了时频增强方法能够显著提升少样本情形下的故障诊断准确率。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	胡向东
	梁川
	杨希

关键词 ：计量学, 滚动轴承, 故障诊断, 时频增强, 少样本

Abstract：Aiming at the problem of low fault diagnosis accuracy due to the scarcity of fault samples of rolling bearings and the difficulty in extracting vibration features, a fault diagnosis method of rolling bearings with few samples based on time-frequency enhancement is proposed. Firstly, one-dimensional vibration signals of rolling bearings are overlapped and sampled, and a two-dimensional time-frequency matrix is constructed by using continuous wavelet transform to map the sampled signals in time-frequency domain. Secondly, the real time-frequency samples are trained by deep convolutional generative adversarial network, and the generated time-frequency samples are added to the training set. Then, the time-series convolutional network is used to fuse the deep time-frequency domain features. Finally, Softmax classifier is constructed to output states corresponding to fault categories. Simulation experiment results show that under the condition of only 10 training samples, the method in the diagnosis of rolling bearing at case western reserve university data set average accuracy of 91.00%, compared with an enhanced time-frequency method is increased by 7.56%, and the time-frequency method is validated by the measured data can significantly improve the fault diagnosis accuracy of less sample circumstances.

Key words： metrology rolling bearing fault diagnosis time-frequency enhancement less sample

收稿日期: 2022-03-09 发布日期: 2023-01-13

PACS:

TB936

基金资助:重庆市自然科学基金(cstc2021jcyj-msxmX0330)

作者简介: 胡向东(1971-),男,四川广安人,重庆邮电大学教授,研究方向为智能感知、网络化测量及工业互联网安全,物联网安全智能理论与技术,复杂系统建模、仿真与优化。Email:huxd@cqupt.edu.cn

引用本文:

胡向东,梁川,杨希. 基于时频增强的滚动轴承少样本故障诊断方法[J]. 计量学报, 2023, 44(1): 12-20.
HU Xiang-dong,LIANG Chuan,YANG Xi. A Method of Fault Diagnosis with Few Samples for Rolling Bearing Based on Time-Frequency Enhancement. Acta Metrologica Sinica, 2023, 44(1): 12-20.

链接本文:

http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2023.01.03 或 http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2023/V44/I1/12

［6］	文成林, 吕菲亚. 基于深度学习的故障诊断方法综述［J］. 电子与信息学报, 2020, 42(1): 234-248.
［13］	Goodfellow I, Pouget-abadie J, Mirza M, et al. Generative adversarial nets［C］//Advances in Neural Information Processing Systems, 2014: 2672-2680.
［1］	ViolaJ, Chen Y Q, Wang J.FaultFace: Deep convolutional generative adversarial network (DCGAN) based ball-bearing failure detection method［J］. Information Sciences, 2021, 542(1): 195-211.
	Li J M, Wang H, Li M, et al. Rolling Bearing Fault Diagnosis Based on Improved Adaptive Parameterless Empirical Wavelet Transform［J］. Acta Metrologica Sinica, 2020, 41(6): 710-716.
［2］	李继猛, 王慧, 李铭, 等. 基于改进的自适应无参经验小波变换的滚动轴承故障诊断［J］. 计量学报, 2020, 41(6): 710-716.
［10］	何强, 唐向红, 李传江, 等. 负载不平衡下小样本数据的轴承故障诊断［J］. 中国机械工程, 2021, 32(10): 1164-1171+1180.
［3］	Wang B J, Zhang X L, Xing S, et al. Sparse representation theory for support vector machine kernel function selection and its application inhigh-speed bearing fault diagnosis ［J］. ISA Transactions, 2021, 118: 207-218.
［4］	Xia T B, Zhuo P C, Xiao L, et al. Multi-stage fault diagnosis framework for rolling bearing based on OHF Elman AdaBoost-Bagging algorithm［J］. Neurocomputing, 2021, 433(4): 237-251.
［5］	Li X, Yang Y, Pan H Y, et al. Non-parallel least squares support matrix machine for rolling bearing fault diagnosis［J］. Mechanism and Machine Theory, 2020, 145(3): 103676.
［8］	Cheng Y, Lin M, Wu J, et al. Intelligent fault diagnosis of rotating machinery based on continuous wavelet transform-local binary convolutional neural network［J］. Knowledge-Based Systems, 2021, 216(3): 106796.
［12］	陈维兴, 崔朝臣, 李小菁, 等. 基于多种小波变换的一维卷积循环神经网络的风电机组轴承故障诊断［J］. 计量学报, 2021, 42(5): 615-622.
［15］	陈剑, 黄凯旋, 吕伍佯, 等. 基于VMD和卷积神经网络的变工况轴承故障诊断方法［J］. 计量学报, 2021, 42(7): 892-897.
	Wen C L, Lv F Y. Review of Fault Diagnosis Methods Based on Deep Learning ［J］. Journal of Electronics & Information Technology, 2020, 42(1): 234-248.
［11］	Han T, Liu C, Yang W G, et al. A novel adversarial learning framework in deep convolutional neural network for intelligent diagnosis of mechanical faults［J］. Knowledge-Based Systems, 2019, 165(2): 474-487.
	Chen W X, Cui C C, Li X J, et al. Bearing Fault Diagnosis of Wind Turbine Based on Multi-wavelet-1D Convolutional LSTM［J］. Acta Metrologica Sinica, 2021, 42(5): 615-622.
［14］	董绍江, 裴雪武, 吴文亮, 等. 基于多层降噪技术及改进卷积神经网络的滚动轴承故障诊断方法［J］. 机械工程学报, 2021, 57(1): 148-156.
［16］	Zhao B X, Yuan Q. Improved generative adversarial network for vibration-based fault diagnosis with imbalanced data［J］. Measurement, 2021, 169(2): 108522.
［7］	Wang X, Mao D X, Li X D. Bearing fault diagnosis based on vibro-acoustic data fusion and 1D-CNN network［J］. Measurement, 2020, 173(3): 108518.
［9］	Dong Y J, Li Y Q, Zheng H L, et al. A new dynamic model and transfer learning based intelligent fault diagnosis framework for rolling element bearings race faults: Solving the small sample problem ［J］. ISA Transactions, 2022, 121: 327-348.
	He Q, Tang X H, Li C J, et al. Bearing Fault Diagnosis with Small Sample Data under Load Unbalance ［J］. China Mechanical Engineering, 2021, 32(10): 1164-1171+1180.
	Dong S J, Pei X W, Wu W L, et al. Rolling Bearing Fault Diagnosis Method Based on Multi-layer Denoising Technology and Improved Convolutional Neural Network ［J］. Journal of Mechanical Engineering, 2021, 57(1): 148-156.
	Chen J, Huang K X, Lü W Y, et al. Bearing Fault Diagnosis Method Based on VMD and Convolutional Neural Network Undervarying Operation Conditions［J］. Acta Metrologica Sinica, 2021, 42(7): 892-897.