基于收缩流动的气体超声流量计声道稀疏化及测量方法

doi:10.3969/j.issn.1000-1158.2022.10.08

摘要
图/表
参考文献(16)
相关文章 (15)

全文: PDF (59266 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要为了提高低声道数超声流量计的准确度水平,在传统超声流量计的基础上设计了一种具有收缩流动结构的低声道数超声流量计。采用数值模拟研究了渐缩管中收缩流动的流场特征,确定了渐缩管的几何参数及超声探头的安装方式。通过空气实流实验,研究了单声道及双声道在收缩流动条件下流量计量的基本特性。在流量范围27~432m3/h,管径范围100~150mm进行了实验验证。结果表明:收缩流动的数值模拟结果与理论模型相吻合,当渐缩管的收缩比由2增大为6,被测流场均匀区占比显著增大;当收缩比固定不变时,随着流量的增大,边界层厚度显著降低。通过实流实验比较不同结构和配置超声流量计的测量结果,发现单声道收缩管超声流量计的准确度水平显著优于传统单声道气体超声流量计,与传统双声道气体超声流量计的准确度水平相当。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	毛显谊
	崔骊水
	谢代梁

关键词 ：计量学, 流量计量, 声道稀疏化, 超声流量计, 渐缩管, 收缩流

Abstract：In order to improve the accuracy level of the low-channel number ultrasonic flowmeter, a low-channel number ultrasonic flowmeter with a shrinking flow structure was designed on the basis of the traditional ultrasonic flowmeter. Focusing on the research content, numerical simulation was used to study the flow field characteristics of the shrinking flow in the reducer, and the geometric parameters of the reducer and the installation method of the ultrasonic probe were determined. Through the air flow experiment, the basic characteristics of the flow measurement of mono and dual channels under contracting flow conditions were studied. The scope of flow studied is 27~432m3/h and the range of pipe diameter is 100~150mm. The research results show that the numerical simulation results of shrinkage flow are consistent with the theoretical model. When the shrinkage ratio of the reducer increases from 2 to 6, the proportion of the uniform area of the measured flow field increases significantly. When the shrinkage ratio is fixed, as the flow rate increases, the boundary layer thickness decreases significantly. Compare the measurement results of ultrasonic flowmeters with different structures and configurations through real flow experiments.The accuracy of the actual flow measurement of single-channel gas ultrasonic flowmeter is superior to that of the traditional single-channel gas ultrasonic flowmeter significantly and is equivalent to the traditional dual-channel gas ultrasonic flowmeter.

Key words： metrology flow measurement channel thinning ultrasonic flowmeter reducer contraction flow

收稿日期: 2021-04-20 发布日期: 2022-10-14

PACS:

TB937

基金资助:国家重点研发计划(2019YFF0216102)

通讯作者: 崔骊水(1979-),男,陕西榆林人,中国计量科学研究院副研究员,从事流速流量计量技术方面的研究。Email:cuils@nim.ac.cn E-mail: cuils@nim.ac.cn

作者简介: 毛显谊(1996-),男,浙江温州人,中国计量大学在读硕士研究生,主要研究方向为气体超声流量计。Email:569870570@qq.com

引用本文:

毛显谊,崔骊水,谢代梁. 基于收缩流动的气体超声流量计声道稀疏化及测量方法[J]. 计量学报, 2022, 43(10): 1291-1297.
MAO Xian-yi,CUI Li-shui,XIE Dai-liang. Channel Thinning and the Measurement Method of Gas Ultrasonic Flowmeter Based on Contraction Flow. Acta Metrologica Sinica, 2022, 43(10): 1291-1297.

链接本文:

http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2022.10.08 或 http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2022/V43/I10/1291

［1］贾承造, 张永峰, 赵霞. 中国天然气工业发展前景与挑战［J］. 天然气工业, 2014, 34(2): 1-11.
Jia C Z, Zhang Y F, Zhao X. Prospects of and challenges to natural gas industry development in China［J］. Natural Gas Industry, 2014, 34(2): 1-11.
［2］许瑞祥, 姚依国, 翟恒涛, 等. 不同管径下外夹式超声流量计仪表系数的实验研究［J］. 计量学报, 2020, 41(z1): 63-67.
Xu R X, Yao Y G, Zhai H T, et all. Experimental Study on Meters Factor of Clamp-on Type Ultrasonic Flowmeter with Different Pipe Diameters［J］. Acta Metrologica Sinica, 2020, 41(z1): 63-67.
［3］Zheng D, Lü S H, Mao Y. Effect mechanism of non-ideal flow field on acoustic field in gas ultrasonic flowmeter［J］. IET Science Measurement Technology, 2019, 13(4):469-477.
［4］Temperler N C, Behnia M, Collings A F. Flow patterns in an ultrasonic liquid flow meter［J］. Flow Measurement and Instrumentation, 2000, 11(1): 11-18.
［5］Sun Y, Zhang T, Zheng D. New Analysis Scheme of Flow-Acoustic Coupling for Gas Ultrasonic Flowmeter with Vortex near the Transducer ［J］. Sensors, 2018, 18(4): 1151.
［6］Chen J, Zhang K, Wang L, et al. Design of a High Precision Ultrasonic Gas Flowmeter［J］. Sensors, 2020, 20(17):4804.
［7］陈红, 聂西利, 丁渊明. 超声波流量计整流器设计及验证［J］. 自动化仪表, 2018, 39(7): 91-93.
Chen H, Nie X L, DING Yuanming. Design and Verification of the Ultrasonic Flowmeter Rectifier［J］. Process Automation Instrumentation, 2018, 39(7):91-93.
［8］Ball C G, Fellouah H, Pollard A. The flow field in turbulent round free jets［J］. Progress in Aerospace Sciences, 2012, 50(none): 1-26.
［9］Feedman E, Otugen M V, Kim S. Effect of Initial Velocity Profile on the Development of Round Jets［J］. Journal of Propulsion and Power, 2012, 16(4): 676-686.
［10］Gngr M A. Analyzing the Fluid Flow of Transit-Time Ultrasonic Flowmeter with Image Processing Technique and Developing a Quality Metric Depending on Pipe Profile［J］. Balkan Journal of Electrical and Computer Engineering, 2020, 8(3): 193-200.
［11］崔航, 胡鹤鸣, 李丽霞, 等. 基于激光跟踪仪的超声流量计几何参数实测方法［J］. 计量学报, 2020, 41(9): 1082-1088.
Cui H, Hu H M, Li X, et al. Geometric Parameter Measurement of Ultrasonic Flowmeter Based on Laser Tracker［J］. Acta Metrologica Sinica, 2020, 41(9): 1082-1088.
［12］王帅, 刘小康, 陆龙生. 直流式低速风洞收缩段收缩曲线的仿真分析［J］. 机床与液压, 2012(11): 100-104.
Wang S, Liu X K, Lu L S. Numerical Analysis on Contraction Curve of Low-speed Blow down Wind Tunnel［J］. Machine Tool & Hydraulics, 2012(11): 100-104.
［13］Fang F M. A Design Method for Contractions with Square End Sections［J］. Journal of Fluids Engineering, 1997, 119(2): 454-458.
［14］Abdel R A. A Review of Effects of Initial and Boundary Conditions on Turbulent Jets［J］. WSEAS Transactions on Fluid Mechanics, 2010, 5(4): 257-275.
［15］Zhang H, Jia L, Cui L S, et al. The Development of Top-Hat Flow Field in a Circular Symmetrical Subsonic Nozzle［J］. Institute of Engineering Thermophysics. 2019,28(5): 975-983.
［16］JJG 1030—2007 超声流量计检定规程［S］. 2007.