2025年05月02日 星期五 首页   |    期刊介绍   |    编 委 会   |    投稿指南   |    期刊订阅   |    统合信息   |    联系我们
计量学报  2023, Vol. 44 Issue (1): 127-131    DOI: 10.3969/j.issn.1000-1158.2023.01.18
  电离辐射、标准物质与生物计量 本期目录 | 过刊浏览 | 高级检索 |
医用诊断半值层测量仪校准影响因素的研究
魏鹏1,王家伟2,李德红3,马伯轩3,郭彬3
1.福建省计量科学研究院,福建 福州 350003
2.安徽省计量科学研究院,安徽 合肥 230051
3.中国计量科学研究院,北京 100029
Research on the Factors Influencing the Calibration of Medical Diagnostic Half-value Layer Instrument
WEI Peng1,WANG Jia-wei2,LI De-hong3,MA Bo-xuan3,GUO Bin3
1.Fujian Institute of Metrology,Fuzhou,Fujian 350003,China
2.Anhui Institute of Metrology,Hefei, Anhui 230051,China
3.National Institute of Metrology,Beijing 100029,China
全文: PDF (558 KB)   HTML (1 KB) 
输出: BibTeX | EndNote (RIS)      
摘要 在各种诊断X射线辐射源检定规程或校准规范中都对半值层测量提出了要求,半值层测量仪也得到广泛应用,但半值层测量仪的校准方法一直未明确。探讨在校准半值层测量仪过程中的主要影响因素,结果表明探测器角度对测量结果影响最大,因此校准时要将被校半值层测量仪置于测试平面中心位置,角度偏差不应超过±1°。
服务
把本文推荐给朋友
加入我的书架
加入引用管理器
E-mail Alert
RSS
作者相关文章
魏鹏
王家伟
李德红
马伯轩
郭彬
关键词 计量学;半值层;辐射质;诊断X射线辐射源校准    
Abstract:The half-value layer measurement is required in various diagnostic X-ray radiation source verification regulations or calibration specifications, and half value layer measuring instruments are also widely used, but the calibration method of half value layer measuring instruments has not been clear. The main influencing factors in the calibration of the half value layer measuring instrument are discussed. The results show that the detector angle has the greatest influence on the measurement results. Therefore, the half value layer measuring instrument to be calibrated should be placed in the center of the test plane during calibration, and the angle deviation should not exceed ±1°.
Key wordsmetrology;HVL;RQR;diagnostic X-ray radiation source    calibration
收稿日期: 2021-02-08      发布日期: 2023-01-13
PACS:  TB98  
基金资助:国家市场监督管理总局能力提升专项(ANL2210)
通讯作者: 郭彬(1980-),男,山西太原人,中国计量科学研究院高级工程师,从事电离辐射计量方面的研究。Email:guobin@nim.ac.cn     E-mail: 56849407@qq.com
作者简介: 魏鹏(1979-),男,山东枣庄人,福建省计量科学研究院高工程师,从事电离辐射计量方面的研究。Email:wp_fz@126.com
引用本文:   
魏鹏,王家伟,李德红,马伯轩,郭彬. 医用诊断半值层测量仪校准影响因素的研究[J]. 计量学报, 2023, 44(1): 127-131.
WEI Peng,WANG Jia-wei,LI De-hong,MA Bo-xuan,GUO Bin. Research on the Factors Influencing the Calibration of Medical Diagnostic Half-value Layer Instrument. Acta Metrologica Sinica, 2023, 44(1): 127-131.
链接本文:  
http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2023.01.18     或     http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2023/V44/I1/127
京ICP备:14006989号-1
版权所有 © 《计量学报》编辑部
地址:北三环东路18号(北京1413信箱)  邮编:100029 电话:(010)64271480
本系统由北京玛格泰克科技发展有限公司设计开发  技术支持:support@magtech.com.cn