|
|
The Design of High-precision Mechanical Vibration Measurement Instrument Based on Amplitude Amplification |
YANG Ji-senZHANG Tian-heng,JIANG Hong-qing,ZHANG Xing-hong |
Engineering Research Center of Mechanical Testing Technology and Equipment, Ministy of Education, Chongqing University of Technology, Chongqing 400054, China |
|
|
Abstract In order to detect the frequency of weak vibration, a method to measure the mechanical vibration is proposed with amplitude amplification, while a mechanical vibration precision measuring instrument is designed on the basis of it. When measured by the amplitude amplifying method, it means to amplify weak vibration amplitude and change it into an electrical signal by a piezoelectric sensing element, and then the signal is sampling by high speed A/D converter and FPGA hardware circuit, and time measurement can reach 0.061ns level under software interpolation subdivision algorithm, so as to realize high-precision frequency measurement.
|
Received: 12 September 2014
Published: 31 May 2016
|
|
|
|
|
[1]樊养余, 李利品, 党瑞荣. 基于随机共振的任意大频率微弱信号检测方法研究[J]. 仪器仪表学报, 2013, 34(3):566-572.
[2]谢平, 杨玉昕, 江国乾,等. 基于局部均值分解的滚动轴承故障诊断新方法[J]. 计量学报, 2014, 35(1): 73-77.
[3]江洪, 刁怀伟, 曹威,等. 电动汽车减速器振动特性分析及噪声辐射预测[J]. 重庆理工大学学报:自然科学版, 2016, 30(1):7-14.
[4]谢平, 江国乾, 武鑫,等. 基于多尺度熵和距离评估的滚动轴承故障诊断[J]. 计量学报, 2013, 34 (6): 548-553.
[5]马艳龙, 李映辉. 求解变截面梁振动特性的假设模态法[J]. 重庆理工大学学报:自然科学版, 2015, 29(4):37-39.
[6]佘银柱,吕 明,王时英. 1/2波长复合变幅杆的数值设计[J].太原理工大学学报,2011,42(6):630-633.
[7]林敏,陈希武,周兆经.基于正交小波包的瞬时频率检测[J].计量学报,2000,21(3):227-231.
[8]李国利,刘旭明,翟力欣.基于FPGA与单片机的等精度频率计的设计[J].电子设计工程,2013,21(22):171-173.
[9]王宏利, 程旭德, 徐 兵, 等. 基于AT89C51 的智能测频仪设计[J].计算机测量与控制,2007,15(3):40-41. |
|
|
|