|
|
Multiple Inductive Current Dividers Calibration on Equipotential Working Condition |
YANG Di1,LIN Jun1,ZHANG Jiangtao2,SHI Zhaomin2,PAN Xianlin2 |
1. School of Instrument Science and Electrical Engineering,Jilin University,Changchun,Jilin 130026,China
2. National Institute of Metrology,Beijing 100029,China |
|
|
Abstract A method for calibration of multiple inductive current dividers (MICD) is proposed.The I/V converter consisting of a voltage follower and a resistor is introduced in the calibration circuit, resulting in the same status for the current ratio of the branches of the MICD both in the calibration and the actual working condition.The MICD with 11 branches has been calibrated compared with an independent reference current provided by a reference current transformer (CT) used to avoid the influence on the current ratio of the branches.The MICD were calibrated at 20、 55、 400Hz and 1kHz.The results showed that the measurement standard uncertainty of ratio errors were better than 0.2μA/A and phase errors were better than 1.5μrad at the ratio of 10:1.
|
Received: 14 September 2023
Published: 04 July 2024
|
|
|
|
|
[10] |
张先庭, 陈琼, 邓洪峰. 交流功率测量相位偏移补偿的研究 [J]. 电测与仪表, 2013, 50(1): 42-46.
|
[2] |
施昌彦. 现代计量学概论[M]. 北京: 中国计量出版社, 2003: 5-10.
|
|
SHEN P Z. Development of Electromagnetic Units of Measurement and Their Benchmarks[J].China Metrology, 2004(3): 45-48.
|
[3] |
张钟华, 贺青. 21 世纪电磁计量的展望 [J]. 现代计量测试, 2009, 9(3): 3-6.
|
[5] |
陈海宾, 杨姝楠, 陈丽雯, 等. 基于现场信号仿真技术的电流互感器误差测试技术研究 [J]. 电测与仪表, 2021, 58(2): 133-138.
|
[1] |
潘仙林. 准确测量四端电阻时间常数的关键技术研究[D]. 哈尔滨: 哈尔滨工业大学, 2013.
|
[7] |
金海彬, 王文海. 400 Hz电流互感器检定及量值溯源系统 [J]. 航空计测技术, 2001(2): 17-22.
|
[8] |
陆文骏. 用两端口网络理论设计高准确度电流互感器和感应式分流器 [J]. 计量技术, 1982(5): 11-15.
|
[4] |
沈平子. 电磁计量单位及其基准的发展[J].中国计量, 2004(3): 45-48.
|
|
CHEN H B, YANG S N, CHEN L W, et al. Research on current transformer error testing technology based on field signal simulation technology [J]. Electrical Measurement & Instrumentation, 2021, 58(2): 133-138.
|
|
ZHANG Y F. Development of ac proportional technology [J]. Electrical Measurement & Instrumentation, 1983,20(4): 14-20.
|
[11] |
潘仙林, 石照民, 张江涛, 等. 宽频功率基准中相位测量的关键技术研究 [J]. 计量技术, 2020(5): 35-39.
|
[15] |
余炳光. 感应分流器误差理论研究及补偿模块设计[D]. 合肥: 合肥工业大学, 2019.
|
[22] |
LIU W, PAN X, JIN Z, et al. Design of the current comparator for measuring the current shunts at common ground [C] //CPEM 2016. Ottawa, ON, Canada, 2016.
|
|
YAN J, BAO J H, ZHOU S J, et al. Verification method of high current for standard current transformer [J]. Qinghai Electric Power, 2014, 33(2): 15-17.
|
|
JIN H B, WANG W H. Calibration and traceability system of value of a quantity of 400 Hz current transformer [J]. Aviation Metrology & Measurement Technology, 2001(2): 17-22.
|
[12] |
张佑峰, 张钟华. 用增量法消除干扰因素的影响及用于校验感应式比例量具的参考增量法 [J]. 计量学报, 1983, 4(3): 161-167.
|
[13] |
何小兵, 王乐仁, 金波, 等. 用感应分流器导出工频小电流比例量值 [J]. 电测与仪表, 2013, 50(S1): 102-107.
|
[16] |
熊魁, 姜春阳, 雷民, 等. 感应分流器的误差特性研究及其实验 [J]. 电测与仪表, 2017, 54(8): 80-84.
|
[17] |
BEAED G E. 100: 1 step up Amplifier-Aided Two-stage current transformer with small ratio error at 60 Hz. [J]. IEEE Transactions on Instrumentation & Measurement, 2007, 28(2): 146-152
|
|
ZHANG Y F. A calibration method for inductive current dividers [J] Acta Metrologica Sinica, 1980, 1(2): 132-141.
|
[20] |
PAN X L, ZHANG J T. A Coaxial Time Constant Standard for the Determination of Phase Angle Errors of Current Shunts [J]. IEEE Transactions on Instrumentation & Measurement, 2013, 62(1): 199-204.
|
[23] |
LIU W, PAN X, JIN Z, et al. Self-calibration of the current comparator with common ground [C] //CPEM 2016. Ottawa, ON, Canada, 2016.
|
|
ZHANG Z H, HE Q. Prospects of electromagnetic metrology in the 21st century [J]. Modern Measurement and Testing, 2009, 9(3): 3-6.
|
[6] |
严洁, 包积花, 周树杰, 等. 标准电流互感器大电流检定方法 [J]. 青海电力, 2014, 33(2): 15-17.
|
[9] |
张佑峰. 交流比例技术的发展 [J]. 电测与仪表, 1983,20(4): 14-20.
|
|
PAN X L, SHI Z M, ZHANG J T, et al. Research on key techniques of phase angle error measurement in establishment of the broadband power primary standard [J]. Measurement Technique, 2020(5): 35-39.
|
[14] |
WANG Q, WANG H, XIANG Q. Design and calibration of inductive current Transformer [J]. Advanced Materials Research, 2013, 860-863: 2261-2265.
|
[18] |
张佑峰. 感应分流器的一种校验方法 [J]. 计量学报, 1980, 1(2): 132-141.
|
|
PAN X L, ZHANG J T, SHI Z M, et al. A New Method to Compare Two Shunt-TVC Combinations at Common Ground [J]. Acta Metrologica sinica, 2020, 41(3): 317-321.
|
|
ZHANG X T, CHEN Q, DENG H F. Study of the phase deviation compensation on ac power measurement [J]. Electrical Measurement & Instrumentation, 2013, 50(1): 42-46.
|
|
XIONG K, JIANG C Y, LEI M, et al. Error characteristic study and experiment of inductive current divider [J]. Electrical Measurement & Instrumentation, 2017, 54(8): 80-84.
|
[24] |
ZHANG J, GU Y, PAN X, et al. Determination of Equivalent Inductance of Current Shunts at Frequency Up to 200 kHz [J]. IEEE Transactions on Instrumentation and Measurement, 2013, 62(6): 140-144.
|
|
ZHANG Y F, ZHANG Z H. Using an“Increment Method” to Eliminate the Stray Error Sources and a Derived “Reference Increment Method” for Calibrating the Inductive Ratio Devices [J]. Acta Metrologica sinica, 1983, 4(3): 161-167
|
|
HE X B, WANG L R, JIN B, et al. Derive the proportional value of power frequency small current using an induction splitter [J]. Electrical Measurement & Instrumentation, 2013, 50(S1): 102-107.
|
[19] |
ZHANG J T, PAN X L, LIN J, et al. A New Method for Measuring the Level Dependence of AC Shunt [J]. IEEE Transactions on Instrumentation & Measurement, 2010, 59(1): 140-144.
|
[21] |
潘仙林 , 张江涛, 石照民, 等. 基于二进制电抗分流器实现热电变换器共地测量 [J]. 计量学报, 2020, 41(3): 317-321.
|
[1] |
ZHU Chengfeng,LI Wan,CHEN Jian,SUN Xiaoying,ZENG Jiusun,CAI Jinhui,WANG Zhenyu,LI Jinjin,WANG Xueshen. Research on Fabrication of Flexible Superconducting Circuits[J]. Acta Metrologica Sinica, 2024, 45(7): 929-934. |
|
|
|
|