接触式亮度计校准方法与装置

doi:10.3969/j.issn.1000-1158.2016.03.05

摘要
图/表
参考文献(9)
相关文章 (15)

全文: PDF (350 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要分析了接触式亮度计的结构、测量原理和应用特点,同时设计了一种适于接触式亮度计校准的均匀漫射面源,以此校准3台接触式亮度计并与中国计量科学研究院的接触式亮度计检定标准进行比对,结果表明该校准方法溯源准确,结果有效、可行。最后对几种常用漫射面源应用于接触式亮度计校准的可行性进行了简要讨论。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	卢利根
	张保洲
	陈赤
	刘建
	曾珊珊
	韩强盛

关键词 ：计量学, 接触式亮度计, 校准, 朗伯特性, 均匀漫射面源

Abstract：The structure, measuring principle and applying properties of a contact-type luminance meter are described. And a light source which can provide a uniform diffuse surface is presented and applied to calibrate three contact-type luminance meters. In comparison with the luminance standard in National Institute of Metrology for verifying contact-type luminance meters, this calibrating method shows good traceability and accurate certified value. Finally, the practicality of applying several commonly diffuse surfaces to calibrate contact-type luminance meters is discussed briefly.

Key words： metrology contact-type luminance meter calibration Lambertian characteristics uniform diffuse surface source

收稿日期: 2014-08-19 发布日期: 2016-03-22

PACS:

TB96

基金资助:中央高校基本科研业务费专项(2013NT52)

通讯作者: 张保洲zhangbzh@bnu.edu.cn E-mail: zhangbzh@bnu.edu.cn

作者简介: 卢利根（1986-）,男,江西抚州人,北京师范大学讲师,博士,主要从事光辐射计量与测试研究。reaganlu@bnu.edu.cn

引用本文:

卢利根,张保洲,陈赤,刘建,曾珊珊,韩强盛. 接触式亮度计校准方法与装置[J]. 计量学报, 2016, 37(3): 246-250.
LU Li-gen1,ZHANG Bao-zhou1,CHEN Chi 2,LIU Jian 2,ZENG Shan-shan 1,HAN Qiang-sheng1. Method and Apparatus for Calibrating Contact-type Luminance Meter. Acta Metrologica Sinica, 2016, 37(3): 246-250.

链接本文:

http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2016.03.05 或 http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2016/V37/I3/246