高精度弯管流量计的理论研究和实验验证

doi:10.3969/j.issn.1000-1158.2013.02.04

摘要
图/表
参考文献(8)
相关文章 (15)

全文: PDF (7411 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要通过求取N-S方程数值解的方法对弯管流量计进行理论研究,得出其测量准确度不仅与传感器自身的管径、曲率半径、弯径比、压力测点位置等几何结构尺寸的准确度有关,而且还与测量使用的条件有关。特别是弯管流量计与前后直管段产生的安装偏转角、直管段管径与其自身管径的一致性等环境应用条件会对弯管流量计的高精度使用产生影响。针对上述影响因素,通过对用整体数控加工的、自身带有直管段的弯管流量计进行反复实验, 结果表明:在2σ准则下,弯管流量计可以达到0.5%的测量准确度水平;不同管径情况下,流量系数也具有良好的一致性。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	李少峰
	薛贵军
	孟宪举
	王池
	李志

关键词 ：计量学, 弯管流量计, N-S方程数值解, 准确度, 自身结构尺寸, 环境应用条件

Abstract：The measurement accuracy of elbow flow meter is not only related to the geometry size precision of the sensor itself in diameter, curvature radius, ratio of curvature radius and diameter, and the position of pressure tap , but also related to the condition for resting, according to the calculating N-S equations to testing elbow flow meter in theory level. Especially, the condition of the application circumstance, such as the deflection angle of installation that generated by the elbow flow and the straight section in both in front and rear sides, the consistency between diameter of straight section and the pipe diameter of itself, would influence the precision of the elbow flow meter in application as well. According to the factors motioned above, by repeatedly testing the elbow flow meter which contains straight section itself machined internally with integral NC, it could be proved that the accuracy of the elbow flow meter could reach 0.5 percent under the criteria in 2σ. Meanwhile, for the circumstance in various pipe diameters, the flow factor performed in good consistency as well.

Key words： Metrology; Elbow flow meter; Numerical solution of N-S equations Construction size of itself; Condition for application circumstance

基金资助:重点国家级火炬计划项目（Z2001007）

作者简介: 李少峰（1979-）,男,河北唐山人,河北联合大学机械工程学院讲师,硕士。主要从事流量计量的理论研究及新产品研发。lisf79@sina.com

引用本文:

李少峰,薛贵军,孟宪举,王池,李志. 高精度弯管流量计的理论研究和实验验证[J]. 计量学报, 2013, 34(2): 111-116.
LI Shao-feng,XUE Gui-jun,MENG Xian-ju,WANG-Chi,LI Zhi. The Theoretical Research and Experimental Testing on Elbow Flow Meter in High Precision. Acta Metrologica Sinica, 2013, 34(2): 111-116.

链接本文:

http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2013.02.04 或 http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2013/V34/I2/111