2025年04月06日 星期日 首页   |    期刊介绍   |    编 委 会   |    投稿指南   |    期刊订阅   |    统合信息   |    联系我们
计量学报  2024, Vol. 45 Issue (5): 609-618    DOI: 10.3969/j.issn.1000-1158.2024.05.01
  电磁学计量 本期目录 | 过刊浏览 | 高级检索 |
100V输入宽频带电压比例校验系统研究
姜春阳1,2,聂高宁2,夏胜国1,周峰2,殷小东2
1.华中科技大学,湖北武汉430074
2.中国电力科学研究院有限公司,湖北武汉430074

Research on 100V Wideband Voltage Ratio Calibration System
JIANG Chunyang1,2,NIE Gaoning2,XIA Shengguo1, ZHOU Feng2,YIN Xiaodong2
1. Huazhong University of Science and Technology,Wuhan, Hubei 430074,China
2. China Electric Power Research Institute,Wuhan, Hubei 430074,China
全文: PDF (691 KB)   HTML (1 KB) 
输出: BibTeX | EndNote (RIS)      
摘要 提出一种基于数字采集装置的50Hz~10kHz电压比例校验系统,由电压比例变换和数字采集装置构成。数字采集装置采用了通道切换技术,极大提高数字采集装置测量比例误差的准确度。电压比例变换部分由级联型感应分压器、隔离互感器及高、低压精密电压跟随器构成。为了降低分布参数引起的附加误差,设计了采用双绞线结构的双级隔离互感器;该双级互感器在10kHz范围内幅值误差不大于5×10-6,相位误差不超过10μrad。利用双封装运算放大器特性匹配特征,补偿电压跟随器电路的相位响应,显著提升了低压和高压复合型电压跟随器的相位特性,10kHz范围内,跟随器的幅值误差不大于10×10-6,相位误差不大于20μrad。测量结果表明,校验系统具有较好的测量准确度, 50Hz时的测量偏差不大于1×10-6和1μrad,10kHz范围内,比值误差偏差不大于80×10-6,相位误差偏差不大于60μrad,可满足不同频率场景下的电压比例误差测量需求。
服务
把本文推荐给朋友
加入我的书架
加入引用管理器
E-mail Alert
RSS
作者相关文章
姜春阳
聂高宁
夏胜国
周峰
殷小东
关键词 电学计量电压谐波校准;电压比例;误差校验;感应分压器;电压跟随器    
Abstract:50Hz~10kHz voltage ratio calibration system based on digital acquisition device is proposed. The system is composed of voltage conversion unit and digital acquisition device. The channel switching technology is used to greatly improve the accuracy of voltage ratio with the digital acquisition device. The voltage conversion unit is composed of cascade inductive voltage divider, isolation transformer and high & low voltage precision voltage follower. In this part, the turn-back winding process and so on are proposed to reduce the additional error caused by the stray parameters and the iron core material, and a two-stage isolation transformer with twisted pair structure winding is designed. The amplitude error of the two-stage transformer within the 10kHz range shall not exceed 5×10-6, and the phase error shall not exceed 10μrad. Precise low-voltage and high-voltage composite voltage followers are designed to compensate the phase response by using the characteristic matching of the double-package operational amplifier, which significantly improves the phase characteristics of the voltage follower, within the 10kHz range, the amplitude error of the follower shall not exceed 10×10-6, and the phase error shall not exceed 20μrad.The measurement results indicate that the calibration system has high measurement accuracy, and the measurement deviation at 50Hz is not greater than 1×10-6 and 1μrad. Within the 10kHz range, the ratio error deviation is not more than 80×10-6, and the phase error deviation is not more than 60μrad, which can meet the voltage ratio error measurement requirements in different frequency scenarios.
Key wordselectrical measurement    calibration of voltage harmonic    voltage ratio    error test    inductive voltage divider    voltage follower
收稿日期: 2023-07-13      发布日期: 2024-05-23
PACS:  TB971  
基金资助:国家重点研发计划(2022YFB2403800)
作者简介: 姜春阳(1985-), 黑龙江依安人, 中国电力科学研究院高级工程师, 华中科技大学在读博士, 从事高电压大电流计量技术研究工作。Email:jiangcy2005@126.com
引用本文:   
姜春阳,聂高宁,夏胜国,周峰,殷小东. 100V输入宽频带电压比例校验系统研究[J]. 计量学报, 2024, 45(5): 609-618.
JIANG Chunyang,NIE Gaoning,XIA Shengguo, ZHOU Feng,YIN Xiaodong. Research on 100V Wideband Voltage Ratio Calibration System. Acta Metrologica Sinica, 2024, 45(5): 609-618.
链接本文:  
http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2024.05.01     或     http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2024/V45/I5/609
京ICP备:14006989号-1
版权所有 © 《计量学报》编辑部
地址:北三环东路18号(北京1413信箱)  邮编:100029 电话:(010)64271480
本系统由北京玛格泰克科技发展有限公司设计开发  技术支持:support@magtech.com.cn