超声纵波换能器用于平测时的测距修正方法研究

doi:10.3969/j.issn.1000-1158.2021.06.08

摘要
图/表
参考文献(16)
相关文章 (15)

全文: PDF (2478 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要研究了超声纵波换能器用于平测时的测距修正方法。首先,根据弹性波理论分析了利用平测布置代替对测布置测量波速时的实际物理意义;然后,分析了两种换能器布置方式的真实传播距离并通过设计混凝土试件切割-测量实验进行了两种布置方式的声时对比;最后,根据实验数据在对测回归直线方程的基础上提出了计算换能器平测布置修正测距的最小二乘法。实验结果表明:按平测声时和修正测距求出的波速与对测波速误差小于2%。结论是平测布置可在一定条件下替代对测布置测量波速,但应通过实验来确定换能器之间的测距修正值,且应在实际应用中保持实验中的测量参数以保证所求修正测距的有效性。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	杨予
	包挺
	王毅
	徐浩

关键词 ：计量学, 测距修正, 平测法, 真实传播距离, 超声纵波换能器

Abstract：The method of determining the correction distance when ultrasonic longitudinal wave transducers are used in indirect transmission arrangement is discussed. Firstly, according to the theory of elastic wave, the actual physical meaning of using the indirect transmission arrangement to measure wave velocity instead of the direct transmission arrangement is analyzed. Secondly,the actual propagation distance of the two arrangements are analyzed and transit times of the two arrangements are compared through a designed cutting-measurement experiment on a concrete specimen. Lastly, linear regression equation is obtained from the experimental data of the indirect transmission arrangement and the least square method is proposed to calculate the correction distance for the indirect transmission arrangement. The experiment results show that the difference between the wave velocity calculated with the correction distance and the wave velocity measured with direct transmission arrangement is less than 2%. The conclusion is the indirect transmission arrangement can be used to measure wave velocity instead of the direct transmission arrangement under certain condition. However, the correction distance should be determined from experiments, and measurement parameters in the experiments should be kept in practice to ensure the effectiveness of the correction distance.

Key words： metrology distance correction indirect transmission actual propagation distance ultrasonic longitudinal wave transducer

收稿日期: 2020-06-30 发布日期: 2021-06-23

PACS:	TB92
	TB95

基金资助:住房和城乡建设部项目(2016-K5-045)

通讯作者: 杨予 E-mail: yangyu@zstu.edu.cn

作者简介: 杨予(1975-), 广西武鸣人, 浙江理工大学副教授,从事建筑工程教学和研究工作。Email:yangyu@zstu.edu.cn

引用本文:

杨予, 包挺, 王毅, 徐浩. 超声纵波换能器用于平测时的测距修正方法研究[J]. 计量学报, 2021, 42(6): 738-744.
YANG Yu, BAO Ting, WANG Yi, XU Hao. Study on Determining Correction Distance of Ultrasonic Longitudinal Wave Transducers Used in Indirect Transmission Method. Acta Metrologica Sinica, 2021, 42(6): 738-744.

链接本文:

http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2021.06.08 或 http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2021/V42/I6/738

［1］Ndagi A, Umar A A, Hejazi F, et al. Non-destructive assessment of concrete deterioration by ultrasonic pulse velocity: A review ［C］//IOP Conference Series: Earth and Environmental Science, Kuala Lumpur, Malaysia, 2019, 357: 012015.
［2］ Al Qurishee M, Wu W, Atolagbe B, et al. NonDe-structive Test Application in Civil Infrastructure ［J］. International Research Journal of Engineering and Technology, 2019, 6 (12): 2092-2095.
［3］ Mesquita E, Martini R, Alves A, et al. Non-destructive characterization of ancient clay brick walls by indirect ultrasonic measurements ［J］. Journal of Building Engineering, 2018, 19: 172-180.
［4］ Mesquita E, Martini R, Alves A, et al. Heterogeneity detection of Portuguese-Brazilian masonries through ultras-onic velocities measurements ［J］. Journal of Civil Structural Health Monitoring, 2018, 8 (5): 847-856.
［5］ Gehlot T, Sankhla S S, Gehlot S S, et al. Study of concrete quality assessment of structural elements using ultrasonic pulse velocity test ［J］. Journal of Mechanical and Civil Engineering, 2016, 13 (5): 15-22.
［6］ Lee C H, Jo Y H. Correlation and correction factor between direct and indirect methods for the ultrasonic measurement of stone samples ［J］. Environmental Earth Sciences, 2017, 76 (14): 477.
［7］ Benaicha, Mouhcine, Hafidi, et al. Correlation between the mechanical behavior and the ultrasonic velocity of fiber-reinforced concrete ［J］. Construction & Building Materials, 2015, 101: 702-709.
［8］ Adamatti D S, Lorenzi A, Chies J A, et al. Analysis of reinforced concrete structures through the ultrasonic pulse velocity: Technological parameters involved ［J］. Revista IBRACON de Estruturas e Materiais, 2017, 10 (2): 358-385.
［9］徐存东, 王铭岩, 王燕, 等. 超声波平测法在混凝土早期受冻损伤检测中的应用研究［J］. 华北水利水电学院学报, 2019, 40 (4): 1-9.
Xu C D, Wang M Y, WANG Y, et al. Study on the application of ultrasonic flat measurement method in the detection of early frozen damage of concrete ［J］. Journal of North China university of water resources and electric power (natural science edition), 2019, 40 (4): 1-9.
［10］ Yaman I O, Inci G, Yesiller N. Ultrasonic pulse velo-city in concrete using direct and indirect transmission ［J］. Aci Materials Journal, 2001, 98 (6): 450-457.
［11］万升云,杜卫东. 超声波检测技术及应用［M］. 北京: 石油工业出版社, 2017.
［12］王毅红, 何闯, 仲继清, 等. 机制生土砖专用砂浆力学性能试验研究［J］. 新型建筑材料, 2019, 46 (7): 60-63.
Wang Y H, He C, Zhong J Q, et al. Experimental study on mechanical properties of the special mortar for the mechanical pressing raw-soil bricks ［J］. New building materials, 2019, 46 (7): 60-63.
［13］王正, 王韵璐, 曹瑜, 等. 混凝土变形模量和泊松比的动态测试研究［J］. 工业建筑, 2017, (1): 84-88.
Wang Z, Wang Y L, Cao Y, et al. Dynamic test study of deformation modulus and Poisson ratio of concrete ［J］. Industrial Construction, 2017, (1): 84-88.
［14］骆燕燕, 冯郁竹, 郝良, 等. 超声波法在电连接器接触压力测试中的应用［J］. 计量学报, 2018, 39 (1): 72-76.
Luo Y Y, Feng Y Z, Hao L, et al. Application of Ultrasonic Method in Contact Stress Testing of Electric Connector ［J］. Acta Metrologica Sinica, 2018, 39 (1): 72-76.
［15］吴希. 地下室增层环境下混凝土构件超声波波速-应变关系研究［D］.杭州: 浙江理工大学, 2019: 24-25.
［16］ Jones R, I. Fcoaru I. Recommendations for testing co-ncrete by the ultrasonic pulse method ［J］. Matériaux et constructions, 1969, 2 (4): 275-284.