2025年05月12日 星期一 首页   |    期刊介绍   |    编 委 会   |    投稿指南   |    期刊订阅   |    统合信息   |    联系我们
计量学报  2021, Vol. 42 Issue (3): 365-369    DOI: 10.3969/j.issn.1000-1158.2021.03.17
  无线电、时间频率计量 本期目录 | 过刊浏览 | 高级检索 |
110GHz在片16项误差模型校准件定值方法研究
王一帮1,周瑞1,陈婷2,吴爱华1,刘晨1,梁法国1
1.中国电子科技集团公司 第十三研究所,河北 石家庄 050051
2.北京无线电计量测试研究所, 北京 130039
Investigation into Definition Method for On-wafer 16-term Error Model Calibration Kits Below 110GHz
WANG Yi-bang1,ZHOU Rui1,CHEN Ting2,WU Ai-hua1,LIU Chen1,LIANG Fa-guo1
1. The 13th Research Institute of China Electronics Technology Group Corporation, Shijiazhuang, Hebei 050051, China
2. Beijing Microwave Metrology and Measurement Institute, Beijing 130022, China
全文: PDF (1923 KB)   HTML (1 KB) 
输出: BibTeX | EndNote (RIS)      
摘要 现有商用集总参数校准件电路模型使用简便,但由于校准件电路模型的不完善、电路中参数在提取过程中采用拟合算法等原因,导致其定值准确度受限。从用于高频串扰修正的16项误差模型校准件设计入手,给出了校准件高精度的定值方法——即通过研制辅助的Multiline TRL校准标准,采用测试加仿真的方式对校准件进行定值,并采用定值文件作为定值样式。采用定值过的16项误差模型校准件校准在片测试系统,并与美国NIST基于Multiline TRL的二次校准方法比较,在110GHz内,两者S21相差在0.30dB以内,相位相差1°以内。所不同的是,16项误差模型校准件的个数远低于NIST,并且在校准过程中不需要移动探针。在保证准确度的前提下,大大提高了测试效率。
服务
把本文推荐给朋友
加入我的书架
加入引用管理器
E-mail Alert
RSS
作者相关文章
王一帮
周瑞
陈婷
吴爱华
刘晨
梁法国
关键词 计量学在片测试16项误差模型校准件定值Multiline TRL串扰    
Abstract:The conventional lumped parameter circuit model has been widely used in the definition of calibration kits for on-wafer probing. However, the accuracy of the defined model parameter is not great, due to the non-ideal circuit model and fitting algorithm used in extracting circuit parameters. A more accurate definition method is presented for 16-term calibration kits that is designed to correct the crosstalk at high frequencies. The new definition method is based on measurements of fabricated assistant multiline TRL calibration kits and full-wave simulations. The measurement system corrected by such defined 16-term calibration kits was compared with two-tier calibration method of Multiline TRL proposed by NIST. The results shows excellent agreement between these two techniques, i.e. the difference in transmission magnitude is within 0.30dB and the phase is within 1.0°. The proposed definition method offers appealing advantages over the NIST technique, in terms of smaller number of standards required and fewer movements of probes.
Key wordsmetrology    on-wafer test    16-term error model    definition for calibration kits    multiline TRL    crosstalk
收稿日期: 2019-11-19      发布日期: 2021-03-23
PACS:  TB973  
作者简介: 王一帮(1987-),男,山东济宁人,中国电子科技集团公司第十三研究所工程师,主要从事无线电、电磁极值量参数计量测试的研究。Email: muqunxing@aliyun.com
引用本文:   
王一帮,周瑞,陈婷,吴爱华,刘晨,梁法国. 110GHz在片16项误差模型校准件定值方法研究[J]. 计量学报, 2021, 42(3): 365-369.
WANG Yi-bang,ZHOU Rui,CHEN Ting,WU Ai-hua,LIU Chen,LIANG Fa-guo. Investigation into Definition Method for On-wafer 16-term Error Model Calibration Kits Below 110GHz. Acta Metrologica Sinica, 2021, 42(3): 365-369.
链接本文:  
http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2021.03.17     或     http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2021/V42/I3/365
京ICP备:14006989号-1
版权所有 © 《计量学报》编辑部
地址:北三环东路18号(北京1413信箱)  邮编:100029 电话:(010)64271480
本系统由北京玛格泰克科技发展有限公司设计开发  技术支持:support@magtech.com.cn