车灯模组的照度检测研究

修亚男; 穆平安; 戴曙光; 朱婉仪

doi:10.3969/j.issn.1000-1158.2020.10.06

PDF(1964 KB)

计量学报 ›› 2020, Vol. 41 ›› Issue (10) : 1212-1217. DOI: 10.3969/j.issn.1000-1158.2020.10.06

光学计量

车灯模组的照度检测研究

修亚男,穆平安,戴曙光,朱婉仪

作者信息 +

Research on Illumination Test of Vehicle Lamp Module

XIU Ya-nan,MU Ping-an,DAI Shu-guang,ZHU Wan-yi

Author information +

文章历史 +

摘要

针对在车灯模组的照度检测过程中,车灯模组照度图像采集时由于摄像系统安装位置产生的畸变问题,采用平面模板法,通过畸变校正算法对系统进行畸变校正,减小因图像坐标位置失真造成的测量误差;针对摄像系统像面照度不均匀性对图像灰度值的影响,通过照度均匀度校正实验获取摄像系统的校正系数后,采用基于麦夸特法与通用全局优化算法结合的曲面拟合法对校正系数进行处理,得到像素坐标与校正系数的函数模型,实现图像灰度值的校正。对校正后的摄像系统进行灰度-照度标定,建立灰度-照度关系,提高车灯模组照度检测的精度。实验结果表明:车灯模组照度检测的误差基本控制在10%以内,重复性误差小于1%,具有较高的准确性和可靠性。

Abstract

In order to solve the problem of distortion caused by the installation position of the camera system when the illumination image of the lamp module is collected, the plane template method is used to correct the distortion of the system through the distortion correction algorithm, so as to reduce the measurement error caused by the distortion of the image coordinate position. In view of the influence of the uneven illumination of the image plane on the gray value of the image, the method of plane template is used to correct the distortion of the system. After the correction coefficient of the camera system is obtained in the illumination uniformity correction experiment, the correction coefficient is processed by the surface fitting method based on the combination of Marquardt method and general global optimization algorithm, and the function model of pixel coordinates and correction coefficient is obtained to realize the correction of image gray value. The calibration of the corrected camera system is carried out to establish the relationship between gray level and illuminance, so as to improve the accuracy of illumination detection of lamp module. The experimental results show that the error of illuminance detection of lamp module is basically controlled within 10%, and the repeatability error is less than 1%, which has high accuracy and reliability.

导出引用

修亚男,穆平安,戴曙光,朱婉仪. 车灯模组的照度检测研究[J]. 计量学报. 2020, 41(10): 1212-1217 https://doi.org/10.3969/j.issn.1000-1158.2020.10.06

XIU Ya-nan,MU Ping-an,DAI Shu-guang,ZHU Wan-yi. Research on Illumination Test of Vehicle Lamp Module[J]. Acta Metrologica Sinica. 2020, 41(10): 1212-1217 https://doi.org/10.3969/j.issn.1000-1158.2020.10.06

中图分类号： TB96

参考文献

［1］杨树忠, 张昆. 汽车前照灯照明特性的测试［J］. 汽车电器, 2000, (6):55-57.
Yang S Z, Zhang K. Measurement of lighting characteristics of automobile headlamp ［J］. Automotive electrical appliances, 2000, (6):55-57.
［2］费音. 汽车前照灯国家标准解读［J］. 质量与标准化, 2013, (3):61-64.
Fei Y. Interpretation of national standards for automotive headlamp ［J］. Quality and standardization, 2013, (3):61-64.
［3］付佳, 徐熙平, 张帆. 机动车前照灯检测仪校准器测量系统分析［J］. 电子测试, 2014, (10):16-17.
Fu J, Xu X P, Zhang F. Analysis of the measurement system of the calibrator of the automobile headlamp detector ［J］. Electronic test, 2014, (10):16-17.
［4］陈鲤江, 刘铁根, 李钢, 等. 基于CCD摄影测量的摩托车前照灯配光性能测试研究［J］. 光电子技术与信息, 2006, (3):65-67.
Chen L J, Liu T G, Li Gang, et al. Measurement of motorcycle headlamp light distribution performance based on CCD photogrammetry ［J］. Optoelectronic technology and information, 2006, (3): 65-67.
［5］王磊, 周伟. 基于CCD的公路照明测量系统［J］. 长安大学学报 (自然科学版), 2011, 31 (2):38-41.
Wang L, Zhou W. Road lighting measurement system based on CCD ［J］. Journal of Changan University (natual science edition), 2011, 31 (2): 38-41.
［6］陈仲林, 翁季, 胡英奎, 等. 用数码相机测量亮度分布［J］. 照明工程学报, 2005, (3):11-14.
Chen Z L, W J, Hu Y K, et al. Measurement of luminance distribution with digital camera ［J］. Journal of lighting engineering, 2005, (3): 11-14.
［7］张晓舟, 郭烨波, 郑克哲. 面阵CCD用于目标亮度的测量［J］. 应用光学, 1995, (2):45-47.
Zhang X Z, Guo Y B, Zheng K Z. Measurement of target brightness with area array CCD ［J］. Applied optics, 1995, 16 (2): 45-47.
［8］Hu T, Chen Y N. Design of the linear array CCD acquisition system that line frequency and integration time adjus-table［C］//Proceedings of 2011 International Conference on Electronics and Optoelectronics, Dalian,China, 2011, 2: 253-256.
［9］周拥军, 赵宝奇, 王鹏. CCD成像型亮度计测量方法研究［J］. 电光与控制, 2010, 17 (12):49-52.
Zhou Y J, Zhao B Q, Wang P. Study on measurement method of CCD imaging luminance meter ［J］. Electro optic and control, 2010, 17 (12): 49-52.
［10］顾冰, 詹庆旋, 祝志强. 利用数码相机测量亮度分布的实验研究［J］. 照明工程学报, 2003, (1): 15-18, 23.
Gu B, Zhan Q X, Zhu Z Q. Experimental study on the measurement of luminance distribution by digital camera ［J］. Journal of lighting engineering, 2003, (1): 15-18, 23.
［11］白钊, 白波, 周丽华, 等. CCD摄像机照度检测装置的研制［J］. 应用光学, 2010, 31 (5):772-776.
Bai Z, Bai B, Zhou L H, et al. Development of CCD camera illumination detection device ［J］. Applied optics, 2010, 31 (5): 772-776.
［12］姚剑. 摄像机畸变模型的选择及畸变校正［D］.太原: 山西大学, 2015
.
［13］朱焱丹, 廖俊必, 何子牛. 基于LabVIEW的机器视觉系统的标定［J］. 中国测试, 2009, 35 (6): 54-56.
Zhu Y D, Liao J B, He Z N. Calibration of machine vision system based on LabVIEW ［J］. China Test, 2009, 35 (6): 54-56.
［14］朱婉仪,穆平安,戴曙光. 基于图像匹配的透明车灯部件检测［J］. 计量学报, 2018, 39(3):353-358.
Zhu W Y, Mu P A, Dai S G. Detection of Transparent Lamp Parts Based on Image Matching［J］. Acta Metrologica Sinica, 2018, 39(3):353-358.

［14］曾蒙秀, 宋友桂. 麦夸特算法在X射线衍射物相定量分析中的应用［J］. 地球科学 (中国地质大学学报), 2013, 38 (2):431-440.
Zeng M X, Song Y G. Application of macquatt algorithm in quantitative analysis of X-ray diffraction phase ［J］. Geoscience (Journal of China University of Geosciences), 2013, 38 (2): 431-440.
［15］郭欣雨, 冯仲科, 曹忠, 等. 基于1stOpt软件的树高测量模型［J］. 东北林业大学学报, 2015, 43 (5): 38-41, 83.
Guo X Y, Feng Z K, Cao Z, et al. Tree height mea-surement model based on 1st opt software ［J］. Journal of Northeast Forestry University, 2015, 43 (5): 38-41, 83.
［16］Qi H J, Jiang B H, Chen W Y, et al. Research of Illuminance Measurement of Motor Vehicular Lamp Using Plane Array CCD Device［J］. Laser And Infrared, 1999, 29(4): 235-237.
［17］叶俊. 基于Canny算子的图像边缘检测与提取的算法［J］. 科技资讯, 2007, (34):69-70.
Ye J. algorithm of image edge detection and extraction based on Canny operator ［J］. Science and technology information, 2007, (34): 69-70.