基于智能检测技术的成组砝码量值传递衡量设计研究

doi:10.3969/j.issn.1000-1158.2020.Z1.19

摘要
图/表
参考文献(10)
相关文章 (15)

全文: PDF (709 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要为了提高成组砝码量值传递的效率和测量准确度,全自动智能化检测正逐步替代人工检测。基于全自动智能检测装置的特点和成组砝码量值传递的需求,提出三工位和四工位分量组合法的衡量设计方式,建立数学模型,进行不确定度分析。并把三工位、四工位与传统的五工位分量组合法进行比较分析,通过分析验证适用于智能化检测机器人的三工位和四工位分量组合算法有效可行,有助于推动智能化检测技术在成组砝码量传领域的应用。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	王连芳
	马堃
	刘平
	袁欣
	张凯

关键词 ：计量学, 砝码, 智能检测, 量值传递, 衡量设计

Abstract：In order to improve the efficiency and accuracy of group weight value transfer, automatic intelligent detection is gradually replacing artificial detection. Based on the characteristics of the full-automatic intelligent detection device and the demand of group weight value transfer, the measurement design method of three position and four position component combination method is proposed, the mathematical model is established, and the uncertainty analysis is carried out. By comparing the three position and four position component combination method with the traditional five position component combination method, it is proved that the three position and four position component combination algorithm applicable to intelligent detection robot is effective and feasible, which is helpful to promote the application of intelligent detection technology in the field of group weight measurement.

Key words： metrology weight intelligent detection value transfer measurement design

PACS:

TB932

基金资助:国家质检总局科技计划项目(2015QK124)

作者简介: 王连芳(1976-),女,山东聊城人,山东省计量科学研究院高级工程师,主要从事砝码的计量检测与研究。5Email: 18553159197@163.com

引用本文:

王连芳,马堃,刘平,袁欣,张凯. 基于智能检测技术的成组砝码量值传递衡量设计研究[J]. 计量学报, 2020, 41(12A): 100-105.
WANG Lian-fang,MA Kun,LIU Ping,YUAN Xin,ZHANG Kai. Research on Measurement Design of Group Weight Value Transfer Based on Intelligent Detection Technology. Acta Metrologica Sinica, 2020, 41(12A): 100-105.

链接本文:

http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2020.Z1.19 或 http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2020/V41/I12A/100