2025年04月11日 星期五 首页   |    期刊介绍   |    编 委 会   |    投稿指南   |    期刊订阅   |    统合信息   |    联系我们
计量学报  2013, Vol. 34 Issue (3): 237-241    DOI: 10.3969/j.issn.1000-1158.2013.03.08
  本期目录 | 过刊浏览 | 高级检索 |
基于容量比较法的卧式罐容量表计算方法研究
王金涛,刘子勇,郭立功,佟林,暴雪松,张珑
中国计量科学研究院, 北京 100013
Study on Computation Algorithm for Horizontal Tank Volume Table Based on Volumetric Method
WANG Jin-tao,LIU Zi-yong,GUO Li-gong,TONG Lin,BAO Xue-song,ZHANG Long
National Institute of Metrology, Beijing 100013, China
全文: PDF (366 KB)   HTML (1 KB) 
输出: BibTeX | EndNote (RIS)      
摘要 在卧式罐容量计量容量比较法原理的基础上,讨论了由有限的卧式罐离散(V-H)点计算出全高度量程范围内任意点的容积值的4种计算方法。并以30m3卧式罐为对象进行了试验研究。试验结果表明:Lagrange插值方法、分段线性插值方法、三次多项式拟合方法和三次样条插值方法在中间液位区间的计算结果较为一致;三次样条插值方法计算结果与试验值偏差最小,最大偏差值23.0L,而且稳定性较好;Lagrange插值方法、分段线性插值方法和三次多项式拟合方法在低液位高度或高液位高度的偏差比中间液位区间的计算偏差大;但是在低液位高度和高液位高度区间,由于多节点时边沿振荡原因,Lagrange插值方法的计算偏差大于三次样条插值方法。
服务
把本文推荐给朋友
加入我的书架
加入引用管理器
E-mail Alert
RSS
作者相关文章
王金涛
刘子勇
郭立功
佟林
暴雪松
张珑
关键词 计量学容量计量卧式罐容量表容量比较法    
Abstract:Based on the introduction on the principle of horizontal tank volumetric calibration method, four algorithms for volume table from discrete V-H data points were discussed, which are Lagrange interpolation method, piece-wise linear interpolation method, cubic polynomial fitting method and cubic spline interpolation method. A 30m3 horizontal tank is used as experimental object. Experimental result shows that the computation results of four algorithms have good con-sistence among the middle liquid level interval; for the total interval, the precision and stability of cubic spline interpolation method is best, and the maximal deviation was 23.0 L, compared to the middle of total interval, there existed bigger deviation at the lower and upper ends when Lagrange interpolation method, piecewise linear interpolation method and cubic polynomial fitting method were used; at the lower and upper ends of total interval, the computation error of Lagrange method is bigger than that of the cubic spline method due to the rim oscillation.
Key wordsMetrology    Volume metrology    Horizontal tank    Volume table    Volumetric method
    
基金资助:国家自然科学基金(51105347)
作者简介: 王金涛(1976-),男,山东临沂人,中国计量科学研究院副研究员,主要从事容量计量方面的工作。 wangjt@nim.ac.cn
引用本文:   
王金涛,刘子勇,郭立功,佟林,暴雪松,张珑. 基于容量比较法的卧式罐容量表计算方法研究[J]. 计量学报, 2013, 34(3): 237-241.
WANG Jin-tao,LIU Zi-yong,GUO Li-gong,TONG Lin,BAO Xue-song,ZHANG Long. Study on Computation Algorithm for Horizontal Tank Volume Table Based on Volumetric Method. Acta Metrologica Sinica, 2013, 34(3): 237-241.
链接本文:  
http://jlxb.china-csm.org:81/Jwk_jlxb/CN/10.3969/j.issn.1000-1158.2013.03.08     或     http://jlxb.china-csm.org:81/Jwk_jlxb/CN/Y2013/V34/I3/237
京ICP备:14006989号-1
版权所有 © 《计量学报》编辑部
地址:北三环东路18号(北京1413信箱)  邮编:100029 电话:(010)64271480
本系统由北京玛格泰克科技发展有限公司设计开发  技术支持:support@magtech.com.cn