Study on Velocity Distribution of Pipeline under Fully Developed Condition
CAI Qin1,LIU Dun-li1,HU He-ming2
1. Xinjiang Uygur Autonomous Region Research Institute of Measurement & Testing, Urumqi, Xinjiang 830011, China
2. National Institute of Metrology, Beijing 100029, China
Abstract:In order to analyze the flow velocity distribution of the pipeline and its center symmetry, a plug-in ultrasonic flowmeter is used to measure the flow velocity of each area in the pipeline under the conditions of different installation angles and different flow velocity points. The experimental results show that the velocity of the pipeline decreases from the center to the edge, which is basically symmetrical distribution in the high velocity state and asymmetrical distribution in the low velocity state; the velocity of the area above the pipeline section is slightly larger than the area below, and the velocity of the horizontal centerline area is slightly larger than the vertical centerline area. It is shown that the velocity distribution of the pipeline is not strictly centrosymmetric under the fully developed condition, the change of the installation angle of the multi-channel ultrasonic flowmeter on the pipeline will cause the change of its measurement performance to a certain extent, especially in the low flow rate state.
蔡勤,刘敦利,胡鹤鸣. 充分发展状态下管道流速分布研究[J]. 计量学报, 2020, 41(12A): 37-40.
CAI Qin,LIU Dun-li,HU He-ming. Study on Velocity Distribution of Pipeline under Fully Developed Condition. Acta Metrologica Sinica, 2020, 41(12A): 37-40.
[1]张维一, 龚家彪. 圆管中充分发展紊流的流速分布与平均流速位置的研究[J]. 计量学报, 1983, 4(1): 1-6.
Zhang W Y, Long J B. Study on velocity distribution and average velocity position of fully developed turbulent flow in circular pipe[J]. Acta Metrologica Sinica, 1983, 4(1): 1-6.
[2]薛银春, 龚家彪. 充分发展圆管流流速分布统一模型及其平均流速位置的研究[J]. 计量学报, 1985, 6(4): 274-278.
Xue Y C, Long J B. study on the uniform velocity distibution model and its average velocity position of fully developed circular pipe[J]. Acta Metrologica Sinica, 1985, 6(4): 274-278.
[3]熊玉亭, 苏中地, 林景殿, 等. 利用管道速度分布方程校准大口径气体流量计[J]. 中国计量学院学报, 2011, 22(1): 25-29.
Xiong Y T, Su Z D, Lin J D, et al. To solve the problem of flow measurement of pipes in large diameter by the corresponding velocity distribution equation[J]. Journal of China University of Metrology, 2011, 22(1): 25-29.
[4]朱宁, 李宁, 徐旷宇. 用LDV测量液体管道流速分布的研究[J]. 计量技术, 2018(10): 17-19.
[5]王艳霞, 傅星, 李正光, 等. 高精度的超声波在线流量测量[J]. 计量学报, 2003, 24(3): 202-204, 249.
Wang Y X, Fu X, Li Z G, et al. The Precision On-line Ultrasonic Measurement of Flow[J]. Acta Metrologica Sinica, 2003, 24(3): 202-204, 249.
[6]Jie Y, Hai N J. Design of Multi-channel Ultrasonic Flowmeter based on ARM.[C]//2010 International Conference on Electrical and Control Engineering, Wuhan, 2010.
[7]宋振华. 超声流量计流场分析及导波流量检测方法研究[D]. 北京: 北京工业大学, 2017.
[8]刘敦利, 胡鹤鸣. 圆形管道截面的流速分布实验与分析[J]. 仪器仪表标准化与计量, 2019(6): 43-45.
Liu D L, Hu H M. Experiment and Analysis on Velocity Distribution of Circular Pipeline Cross-Section[J]. Instrument Standardization & Metrology, 2019(6): 43-45.
[9]胡鹤鸣, 王池, 孟涛. 多声路超声流量计积分方法及其准确度分析[J]. 仪器仪表学报, 2010, 31(6): 1218-1223.
Hu H M, Wang C, Meng T. Integration Method of Multi-chord Ultrasonic Flowmeter and Its Accuracy Analysis[J]. Chinese Journal of Scientific Instrument, 2010, 31(6): 1218-1223.
[10]Hu H M, Meng T, Zhang L, et al. Study on Geometric Parameter Measurement and Wight Coefficient Correction of Ultrasonic Flowmeter[C]//FLOMEKO2013, Paris, 2013.
[11]JJG 1030-2007 超声流量计检定规程[S]. 2007.